28 Dr iv e r in f ormation sy stem
Evaluating times, ending or resetting
timing
LAP 5
+ 45:12.9
59:08.B
0 51:10.B
Fig. 24 Display: Fastest and slowest lap tim e and aver·
age ti me
After evaluating the lap times, you can reset
the lap time r data or contin ue recording addi -
tional laps
c::> pag e 28.
Ending timing
.,. To end the last lap, press the upper section
of the rocker switch as you f inish the lap.
The new lap time will not be included in the
final evaluation .
Evaluating times
... Press the I RESET I button for approximate ly
two seconds. The most impor t ant lap re-
sults appear in the display .
Resetting tim ing
... Press the I RESET I button in the tota l results
display
c::> fig. 24 for at least two seconds to
reset a ll the lap timer data to zero .
Total lap time results
The follow ing information appears in the dis-
play c::> fig . 24 :
+ the fastest lap time
the slowest lap time
0 the average lap time
@ Tips
- Saved lap times canno t be individually
deleted from the total resul t s.
- In add ition to the total results c::>fig. 24,
on ly the last two lap times c::> page 2 7,
fig. 22 can be displayed in the lap t imer.
- The saved lap timer va lues will not be
lost after turning the ignition off.
- Lap timer recording can be cont inued at
a later point in time
c::>page 28.
- All values in the lap t imer are dele t ed
only when reset is de liberately selected .
Resuming timing at a later time
After evaluating the lap t imes, there is the op -
tion to resume and cont inue t iming at a later
time .
... Press the
I RESE T ! button until the lap timer
c::> page 28, fig . 24 appears.
... Press the upper section of the rocker switch
to record the new lap time.
... Repea t t he procedure for recording additi on-
al laps as described above <:>
page 2 7, Re-
cording additional lap times .
Evaluating the
tota l results c::> page 28, Evaluating times,
ending or resetting timing .
Speed warning system
Speed warning system
The speed warning system helps you to keep
your driving speed below a set speed limit.
Fig. 25 Disp lay: Speed wa rning
The speed warn ing system warns the driver if
he exceeds a previous ly stored max imum
speed . A warn ing tone will so und as soon as
the ve hicle speed exceeds the set speed by
abo ut 3 mph (3 km/h). At the same time , a
warning symbol appea rs in the display
c::> fig. 25 .
The speed wa rning system has two warning
thresholds
that fu nction independently of ..,.