each other and that have somewhat different
purposes:
Speed warning 1 [i;[i (Canada models)
You can use speed warning 1 to set the maxi-
mum speed wh ile you are driving . This se t t ing
will remain in effect until you t urn off the igni-
tion, assuming that you have not changed or
reset the setting .
The speed warning symbo l
[&1/lDl (Canada
models) in the warn ing 1 display appea rs
when you exceed the maximum speed. It goes
out when the speed falls be low the stored
maximum speed.
The speed warning symbo l will also go out if
the speed exceeds the stored maximum speed
by more than about 25 mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted .
Setting speed warning 1
r=;, page 29 .
Speed warning 2 EDJ/[al (Canada models)
Storing warning 2 is recommended if you al-
ways
want to be reminded of a certa in speed,
for example when you are traveling in a coun-
try that has a general maximum speed limit,
or if you do not want to exceed a spec ified
speed for winter tires.
The speed warning 2 symbol,
[il1ra1 (Canada
models) appears in the display when you ex-
ceed the stored speed limit . Unlike warning 1,
it will not go out until the vehicle speed drops
be low the stored speed limit.
Sett ing speed warning 2
r=;,page 29 .
(1') Tips
Even though you r vehicle is equipped with
a speed warning sys t em, you should still
watch the speedometer to make sure you
are not driving faster than the speed limit.
Dr iv er in f ormation system 29
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the button.
Fig. 26 Section of instrument cluster: Set/Check but·
ton
Storing the maximum speed
.,. Drive at the desired maximum speed.
.,. Press the knob button c::> fig. 26 until the
symbol r=;,page 28, fig. 25 appears.
Resett ing th e maximum speed
.,. Drive the veh icle at a speed of at least
3 mph (5 km/h)
.,. Press the knob for more than 2 seconds.
The speed warn ing symbol
lllH (USA models)/
Hll <Canada models) will appear briefly in the
display when you release the button to indi-
cate that the maximum speed has been stored
successfully. The maximum speed remains
stored until it is changed by pressing the but-
ton again briefly or unt il it is deleted by a
lengthy push on the button .
Speed warning 2 : setting a speed limit
Switches in the wiper arm are used to operate
warning threshold
2.
'----1 @
Fig. 27 Controls
To Next Page
Loading...
