Evaluating times, ending or resetting
timing
LAP 5
+ 45:12.9
59:08.B
0 51:10.B
Fig. 23 Display: Fastest and slowest lap time and aver·
age time
After evaluating the lap times, you can reset
the lap timer data or contin ue recording addi-
tional laps
c:::> page 29.
Ending timing
~
To end the last lap, press t he upper sec t ion
of the rocker switch as you f inish the lap .
The new lap time will not be included in the
final evaluation.
Evaluating times
~
Press the !RESET I button for approximately
two seconds. The most important lap re-
su lts appear in the display .
Resetting timing
~
Press the !RESE T I button in the tota l results
display
c:::> fig. 23 for at least two seconds to
rese t a ll the lap time r data to ze ro.
Total lap time results
The following information appears in the dis-
play
c:::> fig . 23:
+ the fastest lap time
the slowest lap time
0 the average lap time
(D Tips
- Saved lap t imes cannot be ind ividually
deleted from t he total resu lts.
- In add ition to the total resu lts
c:::> fig. 23,
on ly t he last two lap times c:::> page 28,
fig. 21
can be d isplayed in the lap t imer.
Dr iv er in f ormation system 29
- The saved lap ti mer va lues will not be
Lost after turning the ignition off.
- Lap timer recording can be continued at
a later point in time
c:::> page 29.
- All va lues in the lap t imer are deleted
only when reset is deliberately se lected.
Resuming timing at a later time
After evaluating the lap times, there is the op·
tion to resume and continue timing at a later
time .
~
Press the I RESET ! button until the lap t imer
~
page 29, fig . 23 appears.
~
Press the upper section of the rocker switch
to record the new Lap time.
~
Repeat the procedure for recording addi-
tional laps as described above
c:::> page 28,
Recording additional lap times .
Evaluating
th e total res ults ~ page 29, Evaluating
times, ending or resetting timing.
Speed warning system
Speed warning system
The speed warning system helps you to keep
your driving speed below a set speed limit.
Fig. 24 Display: Speed wa rning
The speed warn ing system warns the driver if
he exceeds a p reviously stored max imum
speed . A warning tone will sound as soon as
the vehi cle speed exceeds the set speed by
about 3 mph (3 km/h). At the same time, a
warning symbol appea rs in the disp lay
~ fig. 24.
The speed warn ing system has two warning
thresholds that f unction independe ntly of ..,.
To Next Page
Loading...
