220 What do I do now ?
(D Note
The vehicle has very low gro und clearance.
Make sure that no damage is caused to the
underside of the vehicle when it is being
loaded onto a flat bed truck .
Front towing loop
Do not install the front towing loop until it is
needed.
Fig. 165 Right fron t bumper wit hout grille : Towing
loop fully screwed in
On the right front in the bumper, there is a
threaded ho le behind the air intake grill into
which the towing loop
is screwed .
.. Remove the towing loop from the vehicle
tool kit
Qpage 210 .
.. Pull the lower part of the grill forward and
out .
.. Screw the towing loop tightly into the
threaded hole as far as it will go ¢
fig. 165.
When it is no longer needed, unscrew the
towing loop and put it back into the on-board
toolkit. Make sure to have the towing loop
stored in the vehicle at all times .
When installing the grill for the air duct, be
sure that the tabs on the grill are first insert-
ed into their guides on the vehicle . Then push
the gr ill into position .
A WARNING
If the towing loop is not screwed in as far
as it will go, the thread can pull out when
the vehicle is towed - potentia l risk of an
accident.
(D Tips
Check carefu lly to make sure the hook-up
is secure.
To Next Page
Loading...
