32 Openin g and clo sing
@ Tips
- The remote control key is automatica lly
deactivated when the ignition is switch-
ed on.
- The operation of the remote contro l key
can be temporarily disrupted by interfer-
ence from transmitters in the vicinity of
the veh icle work ing in the same frequen-
cy range (e.g. a cell phone, radio equip-
ment) .
- In order to make sure the locking func-
tion is working, you shou ld always keep
you r eye on the vehicle to make sure it is
proper ly locked.
- Do not use the remote control if you are
ins ide the car, otherwise you may unin-
tentiona lly lock the vehi cle, and then you
would set off the anti-theft alarm when
you try to start the engine or open a
door . In case this happens anyhow, push
the un lock button @.
- Use the panic funct ion only if you are in
an emergency situation.
Resetting the remote control
The remote control must be reset if the vehi-
cle does not unlock.
• Pres s the unlock button ffi on the remo te
control.
• Manua lly unlock the drive r's door lock with
the mechanical key within 30 seconds.
• Press e ither the lock-
ffi or the unlock @ but-
ton to complete the reset sequence.
Operating locks with the key
To lock and unlock the vehicle from the out-
side, turn the key in the lock of the driver's
door.
Fig. 24 Key turns for opening and dos ing
• To unlock the vehicle, turn the key to the
opening position @ ¢
fig. 24 .
• To lock the vehicle, t urn the key in the lock
of the driver's door to the lock pos ition @
¢ .&.-
A WARNING
=
Always read and heed WARNING¢ .&. in
General description on page 30 .
Locking and unlocking the vehicle from
inside
The vehicle can be locked or unlocked from
the inside using the power locking switch .
Fig. 25 Sect ion fro m driver's door: Power locking
switc h
• Press the upper part of the power locking
switch@ to lock the vehicle ¢ _&..
• Press lower pa rt of the switch
al to unlock
t he vehicle.
-
To Next Page
Loading...
