Audi R8 Spyder - Warranty Information; Claim type and coverage details

Technical Service Bulletin
Page 4 of 6
© 2022 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property
rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced,
stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to
other sites, without the prior expressed written permission of the publisher.
2. Update the seat control modules J136, (address word 0036) and J521, (address word 0006) using the SVM action
code as listed in the table below, if necessary:
Model
Old Target Data
Container Number
Old Target Data
Container Version
New Target Data
Container Number
New Target Data
Container Version
(or higher)
SVM Code
Input
R8
Spyder
4S0909856B * 4S0909856C * 36A004
R8
Spyder
4S0909866B * 4S0909866C * 36A004
3. Perform basic settings of the seats via Guided Functions in ODIS Service.
4. Replace any damaged seat backrest panels, rear panel trim panels, and/or the windscreen according to the
repair manuals in Elsa.
Warranty
Claim Type:
• 110 up to 48 Months/50,000 Miles.
• G10 for CPO Covered Vehicles – Verify Owner.
• If the vehicle is outside any warranty, this Technical Service Bulletin is informational only.
Service Number:
7293
Damage Code:
0039