Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove flange shaft (left-side) ⇒ page 94 .
– Pull out oil seal with extractor tool -T20143/2- .
Installing
– Pack space between sealing lip and dust lip -arrow- half full
with sealing grease ⇒ Parts catalogue .
– Drive in new oil seal onto stop using thrust piece -3305- . Take
care to keep seal straight when installing.
– Install flange shaft (left-side) ⇒ page 94 .
– Check gear oil level and top up as required ⇒ page 66 .
1.4 Renewing oil seal for flange shaft (right-
side)
Special tools and workshop equipment required
♦ Thrust piece -3377-
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
98 Rep. Gr.39 - Final drive - differential
To Next Page
Loading...
