Audi TT 2007 - Page 33

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Using a small screwdriver, carefully pry selector lever boot out
of trim for selector lever boot -arrow 1-.
– Pull up both sides of boot and detach boot -arrows 2 and 3-.
– Turn selector lever boot inside out over selector lever handle.
– Using removal wedge -3409- , pry trim panel for centre console
out of centre console -arrows-.
– Unplug electrical connectors and remove trim panel for centre
console.
– Remove bolts -arrows- and detach trim for selector lever boot
-1- together with selector lever display illumination bulb -
L101- .
Installing
• Tightening torque ⇒ page 26 .
Perform installation in reverse sequence of removal.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
2. Selector lever handle, selector lever display illumination bulb L101 - exploded view 29