Audi TT 2007 - Page 41

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -3- from air mass meter -G70- .
– Release clamps -1 and 2- and disconnect air intake hose from
air mass meter -G70- .
– Unbolt front intake duct from lock carrier -4-.
– Remove engine cover panel.
– Detach locking plate -C-.
– Press retaining clip -A- upwards and detach.
– Press selector lever cable off selector shaft lever -arrow- and
pull out of support bracket -D-.
Note
♦ Do not bend or kink the selector lever cable.
♦ -Items 1 and B- can be disregarded.
– Remove Lambda probe after catalytic converter -G130- ⇒
Rep. Gr. 24 .
– Remove tunnel brace and bracket for exhaust system
-arrows-.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
3. Servicing selector mechanism - exploded view 37