Audi TT 2007 - Page 42

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove heat shield -arrows-.
Caution
The flexible joints in the exhaust system can be damaged.
♦ The flexible joints in the front exhaust pipe must not be
bent further than 10°.
– Disconnect exhaust system at clamp -1-.
– Lower front exhaust pipe with catalytic converter and front si‐
lencer slightly and pull out heat shield towards rear of vehicle.
– Re-connect exhaust system at clamp.
– Detach cover for shift unit -arrows-.
– Carefully slide cover for shift unit together with sleeve along
selector lever cable towards front of vehicle, taking care not to
damage sleeve.
Caution
Electronic components of selector mechanism can be dam‐
aged by electrostatic discharge.
♦ Do not touch printed circuit -B- with bare hands.
– Unscrew bolts -arrows-.
– Unclip retaining tabs on both sides and detach detent plate
-A- from shift unit.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
38 Rep. Gr.34 - Controls, housing