Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– When installing air intake hoses with plug-in connections,
make sure retaining clip -arrow- snaps onto retaining lug -A-.
– Observe correct procedure after connecting battery ⇒ Rep.
Gr. 27 .
– Adjust selector lever cable ⇒ page 40 .
– Check gear oil level and top up as required ⇒ page 66 .
– Check coolant level ⇒ Rep. Gr. 19 .
5.1 Tightening torques (installing gearbox)
Tightening torques
Note
♦
Tightening torques apply only to lightly greased, oiled,
phosphated or black-finished nuts and bolts.
♦
Additional lubricant such as engine or gear oil may be used,
but do not use graphite lubricant.
♦
Do not use parts which have been degreased.
♦
Tolerance for tightening torques ±15%.
Securing direct shift gearbox to engine
Item Bolt Nm
1, 3, 6 M12x55 80
5 M12x65 80
7, 8 M10x50 40
9 M10x45 40
10 M12x70 80
A Dowel sleeves for centralising
Note
-Items 2 and 4- can be disregarded.
• Additional tightening torques
⇒ “8 Assembly mountings - exploded view”, page 59 .
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
5. Installing gearbox 55
To Next Page
Loading...
