Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installing
• Tightening torque ⇒ page 81 .
Installation is carried out in reverse sequence; note the following:
Note
♦
Renew gasket and bolts for oil pan.
♦
Renew O-rings -arrows- on connector for mechatronic unit for
direct shift gearbox -J743- .
– Clean sealing surfaces; they must be free from oil and grease.
– Fit oil pan with oil pan gasket and tighten bolts ⇒ page 81 .
Note
Make sure no electrical wiring is trapped when fitting oil pan.
– Lightly lubricate O-rings on connector for mechatronic unit for
direct shift gearbox -J743- with gear oil
– Fill up with gear oil ⇒ page 72 and check gear oil level
⇒ page 72 .
– Observe correct procedure after connecting battery ⇒ Rep.
Gr. 27 .
1.3 Removing and installing mechatronic
unit for direct shift gearbox -J743-
Removing
Proceed as follows:
Caution
Risk of damage to the gearbox.
♦ Do not run the engine or tow the vehicle with the oil pan
removed or when there is no gear oil in the gearbox.
Note
♦
Observe the general repair instructions ⇒ page 8 .
♦
Observe rules for cleanliness when working on the gearbox
⇒ page 10 .
– Drain off gear oil ⇒ page 72 .
– Remove oil pan ⇒ page 82 .
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1. Oil pan, mechatronic unit, gear oil pump - exploded view 85
To Next Page
Loading...
