Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Tighten bolts for mechatronic unit for direct shift gearbox -
J743- ; note correct tightening sequence
⇒ page 81 .
– Engage electrical wire in top retaining tab first -arrow II-, then
in bottom tab -arrow I-.
– Attach connector for -G182- and -G509- , and check that it is
properly engaged.
– Install oil pan ⇒ page 82 .
– Attach electrical connector for mechatronic unit for direct shift
gearbox -J743- and turn retainer to secure connector.
– Install cover for gear oil pump ⇒ page 90 .
– Fill up with gear oil ⇒ page 72 and check gear oil level
⇒ page 72 .
– Connect vehicle diagnostic, testing and information system -
VAS 5051B- .
– Perform basic setting.
1.4 Removing and installing gearbox input
speed sender -G182- and clutch tem‐
perature sender -G509-
Removing
Proceed as follows:
Caution
Risk of damage to the gearbox.
♦ Do not run the engine or tow the vehicle with the oil pan
removed or when there is no gear oil in the gearbox.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1. Oil pan, mechatronic unit, gear oil pump - exploded view 89
To Next Page
Loading...
