Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦
Observe the general repair instructions ⇒ page 8 .
♦
Observe rules for cleanliness when working on the gearbox
⇒ page 10 .
– Drain off gear oil ⇒ page 72 .
– Remove oil pan ⇒ page 82 .
– Remove mechatronic unit for direct shift gearbox -J743-
⇒ page 85 .
– Remove bolt -B-.
– Pull gearbox input speed sender -G182- and clutch tempera‐
ture sender -G509- -item A- out of gearbox together with
wiring.
Installing
• Tightening torques ⇒ page 80 , ⇒ page 82
Installation is carried out in reverse sequence; note the following:
– Lightly lubricate -G182- and -G509- with gear oil.
– Insert -G182- and -G509- in opening on side of gearbox and
secure with bolt
⇒ page 82 .
– Install mechatronic unit for direct shift gearbox -J743-
⇒ page 85 .
– Install oil pan ⇒ page 82 .
– Fill up with gear oil ⇒ page 72 and check gear oil level
⇒ page 72 .
– Connect vehicle diagnostic, testing and information system -
VAS 5051B- .
– Perform basic setting.
1.5 Removing and installing gear oil pump
Removing
Proceed as follows:
Caution
Risk of damage to the gearbox.
♦ Do not run the engine or tow the vehicle with the oil pan
removed or when there is no gear oil in the gearbox.
Note
♦
Observe rules for cleanliness when working on the gearbox
⇒ page 10 .
♦
Observe the general repair instructions ⇒ page 8 .
– Drain off gear oil ⇒ page 72 and leave used oil collection and
extraction unit -V.A.G 1782- in position below gearbox.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
90 Rep. Gr.35 - Gears, shafts
To Next Page
Loading...
