Audi TT 2007 - Page 96

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• If drive shaft -A- for gear oil pump is inserted correctly, dimen‐
sion -a- = approx. 23 mm.
– If necessary, carefully remove any metal particles on sender
wheel -B- (the sender wheel must not be demagnetised).
– Remove paper gasket between gear oil pump and gearbox.
– Remove remaining pieces of paper gasket and clean inside of
gearbox.
– Clean sealing surfaces; they must be free from oil and grease.
– Fit new paper gasket between gear oil pump and gearbox, if
necessary, apply gear oil to hold it in place while assembling.
– Fit gear oil pump -1- onto drive shaft and secure with bolts
⇒ page 82 .
Note
There are different types of bolts -A or B-; observe correct tight‐
ening method
⇒ page 82 .
– Clean sealing surface between gearbox housing and cover for
gear oil pump.
– Fit cover -A- for gear oil pump and secure with bolts
⇒ page 82 .
– Fill up with gear oil ⇒ page 72 and check gear oil level
⇒ page 72 .
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
92 Rep. Gr.35 - Gears, shafts