Audi TT 2007 - Shift Lever and Shift Housing for Vehicles to VIN 8 J-7-013000 Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3 Shift Lever and Shift Housing for Vehicles to VIN 8J-7-013000 Assembly
Overview
Note
Grease bearing areas and slide surfaces with grease -G 000 450 02- .
1 - Retaining Washer
❑ Removing and installing
⇒ page 58
2 - Bushing
3 - Spring
4 - Bushing
5 - Bolt
❑ 6 Nm
6 - Cover
7 - Damper
❑ For spring -18-
8 - Damper
9 - Bearing Shell
10 - Shift Lever Guide
11 - Damping Washer
12 - Gasket
❑ Between shift housing
and floor
❑ Self-adhesive
❑ Adhere to shift housing
13 - Selector Lever
14 - Shift Housing
15 - Bushing
16 - Pivot pin
17 - Guide Bushing
❑ Press onto selector
housing
18 - Spring
❑ Installing ⇒ page 58
19 - Selector Bracket
20 - Bolt
❑ 5 Nm
21 - Gasket
❑ Replace
22 - Base Plate
❑ Replace
❑ Bend open tabs to remove
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
56 Rep. Gr.34 - Controls, Housing