Audi TT 2007 - Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.6 Transmission Shift Lever and Selector Relay Lever to Model Year 2007
Assembly Overview
Note
Grease bearing areas and slide surfaces with grease -G 000 450 02- .
1 - Selector Mechanism Cover
❑ Removing and installing
with transmission instal‐
led, refer to
⇒ “4.15 Selector Shaft”,
page 126
2 - Selector Shaft
❑ Removing and installing
with transmission instal‐
led, refer to
⇒ “4.15 Selector Shaft”,
page 126
3 - Bushing
4 - Retaining Washer
❑ Removing ⇒ page 64
5 - Shaft Seal
❑ Replace, refer to
⇒ “4.14 Selector Shaft
Seal”, page 124
6 - Retaining Washer
7 - Control Cable Retainer
❑ For shift cable to trans‐
mission shift lever -4-
⇒ page 61
❑ Allocation ⇒ page 62
8 -
Nut
❑ Replace
❑ 23 Nm
❑ Self-locking
9 - Transmission Shift Lever
❑ With balance weight
❑ Insert so that master spline aligns with shift rod ⇒ page 64
❑ Installation location ⇒ page 64
❑ Different diameters of the control cable retainer mounting pin ⇒ page 62
10 - Retaining Washer
11 - Control Cable Retainer
❑ For the selector cable on the selector relay lever -2- ⇒ page 61
❑ Allocation ⇒ page 62
❑ Release to adjust selector mechanism ⇒ page 71
12 - Selector Relay Lever
❑ Installation location ⇒ page 64
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 63