Audi TT 207 - Hood Control Cable, Control Cable Operating Lever Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2.5 Hood Control Cable, Control Cable Operating Lever Assembly overview
1 - Front hood Lock
2 - Right cable
❑ For the right lid lock
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.12 Right Hood
Lock Control Cable“,
page 46
3 - Right hood lock
4 - Mount
❑ For the cables to the left
and right lid locks
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.13 Hood Lock
Control Cable Mount“,
page 47
5 - Cover
❑ For the cable
6 - Grommet
❑ For the seal to the pas‐
senger compartment
7 - Bolt
❑ 10 Nm
8 - Operating lever mounting
bracket
❑ Removing and Instal‐
ling, refer to
⇒ “2.2.9 Release Lever
Mounting Bracket“,
page 43
9 - Hood release lever
10 - Retaining clip
❑ For mount with control cable
11 - Left hood lock
❑ Removing and Installing, refer to ⇒ “2.2.8 Left and Right Hood Lock“, page 43
12 - Left cable
❑ For the left lid lock
❑ Removing and Installing, refer to ⇒ “2.2.11 Left Hood Lock Control Cable“, page 46
❑ Adjusting, refer to ⇒ “1.2.6 Hood Lock Cables, Adjusting“, page 18
13 - Cable
❑ For front lid lock
❑ Removing and Installing, refer to ⇒ “2.2.10 Center Hood Lock Control Cable“, page 44
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation 17