HomeLink® -
_______________ ___.
Applies to vehicles: wi th Hom elin k® universal remote contro l
Programming the Homelink ® transmitter
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary.
Fig. 95 Overhead
console: Homelink®
keypad
Fig. 96 Front bumper,
driver side: location of
transmitter unit
Phase 1: programming the overhead keypad
1. Make sure your vehicle is within operating range of the
remote controlled garage door opener.
2. Set the parking brake
~
& in "General information" on
page 110.
3. Turn the ignition on. Do not start the engine!
Controls and equip-
ment
4. Press and hold the two outside Homelink® buttons 0
and @ for approximately 20 seconds until indicator
light @ ~ fig. 95 begins to flash. Then release both
buttons. Do not hold the buttons for longer than 30
seconds.
- This procedure only needs to be performed
once. It
erases the factory-set defau lt codes and does not have to
be repeated to program additional remote controls.
5. Press and hold the Homelink® button
0 ,@ or @ until
the indicator light @ starts flashing
slowly. Release the
button.
- The system will remain in programming mode for 5
minutes. Go to the front of the vehicle and proceed with
phase 2.
Phase 2:
programming the bumper mounted transmitter
6. Hold the original remote control at a distance between 0-
6 in. (0-15 cm) from the bumper below the appropriate
headlight for your vehicle ~ fig. 96 (use the shortest
distance possible) .
7. Aim the remote control just below the driver side head-
light.
8. Press and hold the activation button on the remote
control.
- May be different in Canada . If so, press and re-press
(cycle ) the activation button on your remote control every
two seconds. .,_
Vehicle care
I I
irechnical data
To Next Page
Loading...
