.....
N
a:
@ Tips
For additional
information
on
ESC
and
ABS,
refer
to
¢ page
87.
BRAKE!
<O;
Brake pads
..
(USA models) I rl] (Canada models)
Brake pads!
If
the
warning
light
turns on, immediately con-
tact
your
authorized Audi dealer
or
authorized
Audi Service Facility
to
have
all
brake pads in-
spected. Both sets
of
brake pads on
an
axle
must
always
be
replaced
at
the
same time.
A
WARNING
Driving
with
bad brakes
can
cause a collision
and serious personal injury.
-
If
the
rl] warning
light
or
the
..
warning
light
l)
with
the
message Brake
pads!
comes on in
the
instrument
cluster display,
immediately contact your authorized Audi
dealer
or
authorized Audi Service Facility
to
have
all
brake pads checked
or
replaced
if
necessary.
ffl;f
!f
Safety
systems
-1
T
he
II
(USA
models)
Im
(Canada models) indi-
cator
light
monitors
the
safety systems.
Safety
system
If
the
II
(USA
models)
Im
(Canada models) in-
dicator
light
turns on
or
blinks, there
is
a mal-
function in a safety system.
Drive
to
an
authorized Audi dealer
or
authorized
Audi Service Facility immediately
to
have
the
malfunction corrected.
A
WARNING
-
Have
the
safety systems inspected immedi-
ately. Otherwise, there
is
a risk
that
the sys-
tems
may
not
activate during a collision,
which increases
the
risk
of
serious injury
or
death.
co
.....
<J:)
Lil
.....
:=:
1)
- :
USA
model
s only
Instruments
and
indicator
lights
~
Engine control
If
the
II
indicator
light
turns
on
if
there
is
a mal-
function in
the
engine control.
Drive slowly
to
an authorized Audi dealer
or
au-
thorized Audi Service Facility
to
have
the
engine
checked .
o System indicator
light
(MIL)
The system indicator
light
(MIL)
is
part
of
the
On
Board Diagnostic system
(OBD
II).
The
¢.j sym-
bol
turns on when
the
ignition
is
switched on and
turns
off
again once
the
engine
is
started and
running
at
a steady idle speed. This indicates
that
the
MIL
is
functioning correctly.
The indicator
light
turns on
if
there
is
a malfunc-
tion
in
the engine electronics.
See
an
authorized
Audi dealer or authorized Audi Service Facility
to
have
the
malfunction corrected.
For additional
information,
refer
to
¢ page
17.
!
?\
Engine speed
lim
i
tation
Applies
to
vehicles wit h engine speed limi
tation
(I! Maximum engine speed:
XXXX
rpm
The engine speed
is
automatically
limited
to
the
speed displayed in the driver
information
system.
This protects
the
engine
from
overheating.
The engine speed
limitation
deactivates once
the
engine
is
no longer in
the
critical
temperature
range and you have released
the
accelerator ped-
al once.
If
the
engine speed
limitation
was activated by
an engine
control
malfunction,
the
II
indicator
light
also turns on. Make sure
the
engine speed
does
not
go above the speed displayed,
for
exam-
ple when downshifting. Drive
to
an
authorized
Audi dealer or authoriz
ed
Audi Service Facility
im-
mediately
to
have
the
malfunction corrected.
~
Engine oil level
(min.
)
II
Please
check
oil level
15
To Next Page
Loading...
