Audi TT Coupe 2016 - Repairing Tires; Installing the Tire Mobility Kit; Inflating a Tire

Emergency assistance
The tire repair is only meant for temporary use.
Change the spare t ire as soon as possible ¢ .&. .
If the tire is pierced by an object such as a nail,
do not remove the object from the tire .
The
tire mobility kit is ab le to be used at temper-
atures as low as - 4 °F (- 20 °C).
The tire mobility kit may not be used:
-
If the t ire has cuts or punctures that are larger
than 0.16 in (4 mm) CD ¢ fig. 197.
- if the rim is damaged @ .
- if you drove
with very Low tire pressure or with-
out air in the tire @ .
See an authorized Audi dealer or authorized Audi
Service Facility for
assistance in these situations.
& WARNING
- Please
note that the tire mob ili ty kit cannot
be used in all situations, and that it may on-
ly be used temporari ly.
- The
tire sealant must not come in contact
with skin, eyes, or clothes.
- If tire sealant gets in your eyes or on your
skin, thoroughly rinse the affected area im-
mediately wi th clean water.
- Do not inhale the fumes .
- If you swallow any of the t ire sealant, thor-
oughly rinse your mouth immediately and
drink a lot of water. Do not induce vomiting.
Seek medical attention immediately.
-
Change your clothes immed i ately if they get
tire sealant on them.
- If an allergic reaction occurs, see k immedi-
ate medical attention.
- Keep the tire sealant away from children.
@ Tips
-
If sealant L ea ks, allow it to dry in place. You
can then peel it off like a sticker.
- Note
the expiration date on the sealant bot-
tle . Replace the tire sealant at an author-
iz ed Audi dealer or authorized Audi Service
Facility.
- Radio reception
can be interrupted when
operating the compressor *.
-
Obey all laws.
276
Repairing tires
Applies to: vehicles with tire mo bility kit
Fig. 198 Componen ts of the tire mo bility kit
Fig. 199 Tire mob ility kit connection
Requirement: the tire mobility kit must be laid
out and ready for use ¢ page 2 75 .
Installing the tire mobility
kit
... Open the cover @ on the compressor
¢ fig. 198.
... Remove the connector © and pressure hose ®
with
pressure gauge from the housing.
... Install the compressor pressure hose ® onto
the flange @ of tire sealant bottle @ .
.,. Insert the sea l ant bottle with the flange at the
bottom into the open ing @ on the compressor
cover .
... Remove the valve cap from the faulty tire.
... Insta ll t he filler hose @ onto the valve (j)
¢ fig. 199.
... Connect the plug © <=> fig. 198 to a socket in
the vehicle.
.,. Swi tch on the ignition.
Inflating a tire
... Move the switch @ ¢ fig. 199 on the compres-
sor into position I. ..,.