Audi TT Coupe 2016 - Programming the Transmitter

Opening and c lo s ing
Programming the transmitter
Applies to: vehicles with garage door opener (Homelink)
Fig.
29 Distance between the radiator grille and the re-
mote control transmitter
Programming the butt on: step 1 on the
control panel
1. Sw itch on the ignition.
2.
Press both of the outside buttons on the con-
trol panel Q page 33, fig. 28 until the yellow
LED @ turns off and the green LED @ blinks.
This procedure clears
the standard codes that
were set at the factory and does not need to
be repeated again to program the other but-
tons.
3. Briefly press the button in the control panel
that you want to program.
4. Wait until the yellow LED @ blinks. The pro-
gramming mode is active for 5 minutes.
5.
Go in front of the vehicle with the original re-
mote control transmitter for the system that
you are programming to the control panel
button.
Programming the butt on: s tep 2 at the
radiator grille
6. Ho ld the remote control transmitter at the
vehicle radiator grille c:> fig. 29.
7. Now press the remote control transmitter
until the turn signals on your vehicle blink.
This can
take up to 30 seconds.
8.
If the emergency flashers blink three times,
the programming was successful. If the
emergency flashers only blink one time, the
5 minute time limit for programming has ex-
pired
or the programming was unsuccessful.
Repeat the programming starting from the
third step or change the distance to the radi-
ator grille.
34
9. If the garage door or other systems do not
open with the Homelink buttons even if the
programming was successful, the system
may use a rolling code instead of a fixed
code.
You must also then perform rolling
code
programm ing Q page 35.
The other two buttons in the control panel can be
programmed using the instructions given above.
Start with step 3.
Deleting butt on programming
The programmed buttons cannot be deleted indi-
vidually, they
must be deleted all at once. Repro-
gram the buttons if necessary.
... Switch on the ignition.
... Press both of the outside buttons on the con-
trol unit until the yellow LED @ turns off and
the green LED @ blinks.
Reprogramming button s
... Switch on the ignition.
... To reprogram an individual button, press the
desired button until the green LED @ turns off
and the yellow LED @ starts to blink (after ap-
proximately
20 seconds). Release the button
immediately. The programming mode is active
for S minutes.
... Continue with step 5.
(!) Tips
- The distance needed between the remote
control transmitter and the Homelink mod-
ule in the radiator grille c:> fig. 29 depends
on the system you are programming.
- Depending on the system model, you may
need
to release the button on the remote
control transmitter while it is programming
and press it again. Hold every position you
try when programming for at least 15 sec -
onds before trying a new position. Keep an
eye on the vehicle turn signals while doing
this.