Rolling code programming
A
ppl
ies to:
ve
hicles
with
garage door opener
(Homeli
nk)
On
some systems,
programming
a rolling code
is
also necessary.
Identifying a rolling code
~ Press
the
button
in
the
control
un
it
that
is
al-
ready programmed again and hold it down.
~
Pay
attention
to
the
LED
@ ¢ page 33, fig.
28.
If
the green
LED
blinks quickly,
the
system
(such as a garage door) has a rolling code.
~P
rogram
the
rolling code as follows:
Activating
the
system
motor unit
~
Locate
the
programming button
on
the
system
motor unit. The exact location and color
of
the
button may vary depending on
the
system man-
ufacture r's brand.
~P
ress
the
programming button on
the
system
motor unit (usually this w
ill
activate a
"d
isplay"
on
the
motor unit).
You
now have approximate-
ly
30
seconds to program the button
in
the
control pane
l.
Programming
the
button
in
the
control
panel
~
Press
the
previously programmed button
in
the
control panel for 2 seconds.
~T
o
complete
ro
l
ling
code programming, press
the
button again for 2 seconds.
~
On
some systems,
the
button mi
ght
need to be
pressed a third time to end
the
programming
procedure.
After programming,
the
system should recognize
the
signal and operate when
the
button
in
the
control panel is pressed.
Now
you may program
the
other buttons as needed.
(})
Tips
- The rolling code can be programmed more
quickly and more easily with
the
help of a
second person.
-
If
any difficulties occur when programming
the
rolling code, it may be helpful to read
the
system operating manual.
Opening
and
closing
35
To Next Page
Loading...
