Audi TT Coupe 2016 - Adjusting the Display and the Warning Tones; Error Messages

Parking systems
in the parking space c) fig. 86. Use the mark-
ings @
to help you est i mate the di stance from
an obstacle. Each marking represents approxi-
mately 3 ft (1 m). The blue area represents an
extension of the vehicle's outline by approxi-
mately 16 ft (5 meters) to the rear.
.,.. While driving in reverse gear, adjust the steer-
ing wheel angle to fit the parking space using
the orange orientation lines for assistance
c) .&. in General information on page 84, c) (i)
in General information on page 85. @ displays
the rear bumper. Stop the vehicle, at the l ates t,
when
the red or i entation line @ borders an ob-
ject.
Adjusting the display
and the warning tones
Applies to: ve hicles with parking system plus
The display and warning tones can be adjusted in
the Infotainment.
.,.. Select in the Infotainment system: I MENUI but-
ton > Vehicle > left control button >Dri ver as-
sistance > Parking aid.
Warning tones
Front volume - volume for the front area
Rear volume - volume for the rear area
Entertainment fader - when the parking syst em
is turned on, the volume of the audio/video
source
is lowered.
Th e newly selected level is demonstrated br iefly
by the sound
generator.
(}) Tips
Th e se t tings are automatically stored and as-
signed to the remote control key that is in
use.
Error messages
Applies to: vehicles with rear parking system/parking system
plus
Rear parking aid: malfun ction! Obstacles not
detected
Front park i ng aid: malfunction! Obstacles can-
not be detected
86
Parking aid: malfunction! Obstacle s cannot be
detected
There is a system malfunction if the LED in the
pg~ button blinks when switching on the system.
If the error is not corrected before you switch off
the ignition, the LED in the pg ~ button will blink
the next time you switch on the parking system
by shifting into reverse. As long as the error is ac-
tive, you can display
the error messages in the
second t ab of the driver information system.
Parking system plus*
If a sensor or speaker is faulty, the JM symbol
will
appear in front of/behind the vehicle in the
Infotainment display. If a rear sensor is faulty,
only o
bstacles th at are in areas @ and @ are
shown c) page 83, fig. 80. If a front sensor is
faulty, only obstacles that are in areas © and @
are shown.
Drive
to an authorized Audi dealer or authorized
Audi Service Facility immediately
to have the
malfunction corrected.