Need help?Do you have a question about the Audio Design Associates Suite 16 and is the answer not in the manual?
General| Channels | 16 |
|---|---|
| Total Harmonic Distortion | <0.005% |
| Outputs | 16 |
| Frequency Response | 20Hz - 20kHz |
| Power Supply | 240V AC, 50/60Hz |
Chassis holds up to three Suite 16 Modules, features power/reset switch, RS-232 port, and removable window.
Compensates for varying source component output levels via software.
Two 9-pin connectors providing 12VDC output when an input is selected for source activation.
Controls components without serial/IR, uses eight relays activated by transport buttons.
Balanced audio input for paging via a 5-pin screw terminal connector.
Limits paging signal level, adjustable via trim pot.
Software-set paging volume, independent of music volume.
Features audio sensing and low voltage triggers for paging activation.
Sixteen stereo RCA outputs with independent zone control.
Each zone accesses any audio input independently with serial commands.
Independent control per zone with up, down, and direct serial commands.
Six Channel Amplifier used with ACC-3, triggered by low voltage signals.
Sixteen video inputs per module, supports Y-splitting composite video.
Sixteen video outputs per module for connection to displays.
Links video inputs to audio selections or operates them independently.
Sixteen inputs/outputs allow for CCTV cameras or touch screen controls.
9-pin D connectors provide +12VDC signal upon video output selection for triggering.
Routes 16 audio components to 16 audio zones.
Configures 32 audio zones using one A-16 and two P-16s.
Adds video switching to 16 audio zones.
Rotary DIP switch sets module address for matrix switching, with feedback disable options.
Adds 16 zones to the primary unit without an A-16 module.
Adds 32 zones to the primary unit.
Adds 48 zones to the primary unit.
Configures a second chassis with P-16 and V-16 modules.
Direct connection to RS-232 for non-ADA control systems.
Networks ADA Bus components using WH-2000 and ISO-232.
Specification for ADA Bus wire and recommended run length limits.
Wiring keypads using Cat. 5 cable and RJ-45 connectors.
Configures baud rate, data bits, stop bit, and parity.
Adds ISO-232 for electrical isolation and ground loop prevention.
Specifies use of straight-through 9-pin D-style RS-232 cable.
Selects Com port, requests module versions, and tests audio/video inputs.
Selects video input for a specific room or turns video off.
Links video inputs to audio selections or allows independent video operation.
Enables or disables hardware trigger control inputs.
Assigns rooms (video outputs) to specific video triggers.
Assigns specific video inputs to triggers.
Explains serial control at 19200/1200 baud and the 10-character command structure.
Details the format of system feedback responses.
Global command to power down the entire system.
Advances to the next audio input for a room, with rollover.
Decrements to the previous audio input for a room, with rollover.
Lists serial command codes for preamplifier functions.
To Next Page