To Next PageTo Next Page
Need help?Do you have a question about the AUDIO TELEX TX8000 and is the answer not in the manual?
General| Brand | AUDIO TELEX |
|---|---|
| Model | TX8000 |
| Category | Mixer |
| Language | English |
Adjusts the mix level for each input channel. Start at Level 0 and turn clockwise for desired level.
Recessed control for adjusting bass response (+/- 12dB @ 100Hz). Center position provides flat response.
Recessed control for adjusting treble response (+/- 10dB @ 10KHz). Center position provides flat response.
Sets the overall mixer output level based on individual input channel levels. Adjust clockwise for more output.
7-segment LED meter indicating signal level from -21 to +3 dB. Helps prevent distortion.
1/4" RTS stereo socket for monitor headphones. Output level is nominal 3.5V @ 600 ohms.
Connects AC mains power (240 VAC @ 50 Hz or 110 VAC @ 60 Hz). Equipped with a 1 Amp fuse.
Allows for external cable egress for accessories such as tone generators.
Connects to a 2.1mm socket for DC operation. Maximum DC current drain is 350 mA.
Active balanced XLR connection with a nominal level of 1.5 volts @ 600 ohms.
Nominal 700mV @ 10K ohms. Output is summed to mono and unaffected by master level control.
Input sensitivity 0.6mV @ 200 ohms. Phantom power (+18 volts) is available.
Summed to mono buss, input sensitivity 50mV-500mV @ 47K ohms for channels 1-6.
3-pin link on output board behind Mic #8 XLR socket. Default is 'on'.
Trim pots (R*1-R*8) on input circuit board at rear of mixer for adjusting trim level.
