Version 5.8 133 September 2009
SIP User's Manual 3. Web-Based Management
Table 3-23: Tel to IP Routing Table Parameters
Parameter Description
Web/EMS: Tel to IP Routing
Mode
Determines whether to route Tel calls to IP before or after
manipulation of destination number.
[RouteModeTel2IP]
[0]
Route calls before manipulation = Calls are routed before the
number manipulation rules are applied (default).
[1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
Notes:
This parameter is not applicable if outbound Proxy routing is
used.
For number manipulation, refer to ''Configuring the Number
Manipulation Tables'' 124 on page .
Web: Src. Trunk Group ID
EMS: Source Trunk Group ID
The source
[PREFIX_SrcTrunkGroupID]
Hunt Group ID of the call.
The range is 1-99.
If this parameter is not required in the routing rule, leave the field
empty.
Notes:
To denote any Hunt
Web: Dest. Phone Prefix
EMS: Destination Phone
Prefix
Group, you can enter the asterisk (*) symbol.
Called telephone number prefix.
The prefix can include up to 50 digits.
[PREFIX_DestinationPrefix]
Note: The destination phone prefix can be a single digit or a range of
digits. For available notations representing multiple numbers/digits,
refer to ''Dialing Plan Notation for Routing and Manipulation''
377
on page
.
Web/EMS: Source Phone
Prefix
Calling telephone number prefix.
The prefix can include up to 50 digits.
[PREFIX_SourcePrefix]
Note: The source phone prefix can be a single digit or a range of
digits. For available notations representing multiple numbers/digits,
refer to ''Dialing Plan Notation for Routing and Manipulation''
377
on page
.
All Tel calls matching all or any combination of the above routing rules are subsequently sent to the
destination IP address defined below.
For alternative routing, additional entries of the same prefixes can be configured.
Notes:
For notations representing multiple numbers, refer to ''Dialing Plan Notation for Routing and
Manipulation'' 377 on page .
To Next Page
Loading...
