Parameter Description
Channel Select Mode The method for which IP-to-Tel calls are assigned to channels
pertaining to a
[TrunkGroupSettings_Chann
elSelectMode]
Hunt
Group. For a detailed description of this
parameter, refer to the global parameter ChannelSelectMode.
[0]
By Dest Phone Number.
[1]
Cyclic Ascending (default)
[2]
Ascending
[3]
Cyclic Descending
[4]
Descending
[5]
Dest Number + Cyclic Ascending
[6]
Registration Mode
By Source Phone Number
Registration method for the
[TrunkGroupSettings_Regist
rationMode]
Hunt
Group:
[1] Per Gateway = Single registration for the entire device
(default). This mode is applicable only if a default Proxy or
Registrar IP are configured, and Registration is enabled (i.e.,
parameter IsRegisterUsed is set to 1). In this mode, the SIP URI
user part in the From, To, and Contact headers is set to the
value of the global registration parameter GWRegistrationName
(refer to ''Configuring Proxy and Registration Parameters''
94
on
page ) or username if GWRegistrationName is not
configured.
[0] Per Endpoint = Each channel in the Hunt
Group registers
individually. The registrations are sent to the ServingIPGroupID
if defined in the table, otherwise to the default Proxy, and if no
default Proxy, then to the Registrar IP.
[4] Don't Register = No registrations are sent by endpoints
pertaining to the Hunt Group. For example, if the device is
configured globally to register all its endpoints (using the
parameter ChannelSelectMode), you can exclude some
endpoints from being registered by assigning them to a Hunt
Group and configuring the Hunt
Group registration mode to
'Don't Register'.
[5] Per Account = Registrations are sent (or not) to an IP Group,
according to the settings in the Account table (refer to
''Configuring the Account Table'' 102 on page ).
Notes:
To enable
Hunt
If no mode is selected, the registration is performed according
to the global registration parameter ChannelSelectMode (refer
to ''
Group registrations, configure the global
parameter IsRegisterNeeded to 1. This is unnecessary for 'Per
Account' registration mode.
Configuring Proxy and Registration Parameters''
94
on page
).
If the device is configured globally (ChannelSelectMode) to
register Per Endpoint, and a Hunt Group comprising four FXO
endpoints is configured to register Per Gateway, the device
registers all endpoints except the first four endpoints. The Hunt
Group of these four endpoints
sends a single registration
request.
To Next Page
Loading...
