AudioCodes Media Pack MP-124 - Page 332

SIP User's Manual 332 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
''Format of ini File Table Parameters'' 191 on page .
IP to Hunt
IP to
Group Routing Table
Hunt Group Routing Table
This
[PSTNPrefix]
ini file table parameter configures the routing of IP calls to
Hunt
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_
Groups. The format of this parameter is as follows:
DestPrefix,
PstnPrefix_TrunkGroupId, PstnPrefix_SourcePrefix,
PstnPrefix_SourceAddress, PstnPrefix_ProfileId,
PstnPrefix_SrcIPGroupID, PstnPrefix_DestHostPrefix,
PstnPrefix_SrcHostPrefix
For example:
PstnPrefix 0 = 100, 1, 200, *, 0, 2, , ;
PstnPrefix 1 = *, 2, *, , 1, 3, acl, joe;
;
[\PSTNPrefix]
 This parameter can include up to
Notes:
24
 For a description of these parameters, refer to the
corresponding Web parameters in ''
indices.
Configuring the IP to
Trunk Group Routing Table'' 135 on page .
 To support the In-Call Alternative Routing feature, you can
use two entries that support the same call, but assigned with
a different Hunt
 Selection of
Group. The second entry functions as an
alternative selection if the first rule fails as a result of one of
the release reasons listed in the AltRouteCauseIP2Tel table.
Hunt
 The source IP address (SourceAddress) can include the 'x'
wildcard to represent single digits. For example: 10.8.8.xx
represents all IP addresses between 10.8.8.10 and
10.8.8.99.
Groups (for IP-to-Tel calls) is according to
destination number, source number,and source IP address.
 The source IP address (SourceAddress) can include the
asterisk ('*') wildcard to represent any number between 0 and
255. For example, 10.8.8.* represents all addresses between
10.8.8.0 and 10.8.8.255.
 If the source IP address (SourceAddress) includes an FQDN,
DNS resolution is performed according to DNSQueryType.
 For available notations that represent multiple numbers, refer
to ''Dialing Plan Notation for Routing and Manipulation''
377
on
page .
 For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters'' 191 on page .
Web/EMS: IP to Tel Routing
Mode
Determines whether to route IP calls to the
[RouteModeIP2Tel]
Hunt Group before or
after manipulation of destination number (configured in
''Configuring the Number Manipulation Tables'' 124 on page ).
 [0]

Route calls before manipulation = Calls are routed before
the number manipulation rules are applied (default).
[1]
Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.