[SourceNumberMapIp2Tel]
FORMAT SourceNumberMapIp2Tel_Index =
SourceNumberMapIp2Tel_DestinationPrefix,
SourceNumberMapIp2Tel_SourcePrefix,
SourceNumberMapIp2Tel_SourceAddress,
SourceNumberMapIp2Tel_NumberType,
SourceNumberMapIp2Tel_NumberPlan,
SourceNumberMapIp2Tel_RemoveFromLeft,
SourceNumberMapIp2Tel_RemoveFromRight,
SourceNumberMapIp2Tel_LeaveFromRight,
SourceNumberMapIp2Tel_Prefix2Add,
SourceNumberMapIp2Tel_Suffix2Add,
SourceNumberMapIp2Tel_IsPresentationRestricted
For example:
[SourceNumberMapIp2Tel]
SourceNumberMapIp2Tel 0 =
22,03,$$,$$,$$,$$,2,667,$$,$$;
SourceNumberMapIp2Tel 1 =
034,01,1.1.1.1,$$,0,2,$$,$$,972,$$,10;
[\SourceNumberMapIp2Tel]
;
[\SourceNumberMapIp2Tel]
Notes:
RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add,
The parameters
SourceNumberMapIp2Tel_NumberType,
SourceNumberMapIp2Tel_NumberPlan and
SourceNumberMapIp2Tel_IsPresentationRestricted are
not applicable. Set these to $$.
and
The manipulation rules are executed in the following
order: RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and Suffix2Add.
LeaveFromRight are applied if the
called and calling numbers match the DestinationPrefix,
SourcePrefix, and SourceAddress conditions.
Parameters can be skipped by using two dollar signs
('$$').
The Source IP address can include the 'x' wildcard to
represent single digits. For example: 10.8.8.xx
represents all addresses between 10.8.8.10 and
10.8.8.99.
The Source IP address can include the asterisk ('*')
wildcard to represent any number between 0 and 255.
For example, 10.8.8.* represents all the addresses
between 10.8.8.0 and 10.8.8.255.
To configure manipulation of source numbers for IP-to-
Tel calls using the Web interface, refer to ''Configuring
the Number Manipulation Tables'' 124 on page ).
For a description on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' 191 on page .
To Next Page
Loading...
