User's Manual 1154 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
RedirectNumberMapTel2Ip_IsPresentationRestricted,
RedirectNumberMapTel2Ip_SrcTrunkGroupID;
[\RedirectNumberMapTel2Ip]
For a description of the table, see ''Configuring Redirect Number
Manipulation'' on page 513.
Phone Contexts Table
Phone Contexts
configure voip > gateway
manipulation phone-context-
table
[PhoneContext]
Defines the Phone Context table. The parameter maps NPI and
TON to the SIP 'phone-context' parameter, and vice versa.
The format for the parameter is as follows:
[PhoneContext]
FORMAT PhoneContext_Index = PhoneContext_Npi,
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
For a detailed description of the table, see ''Configuring NPI/TON-
SIP Phone-Context Mapping Rules'' on page 519.
Add Phone Context As Prefix
configure voip > gateway
manipulation settings > add-ph-
cntxt-as-pref
[AddPhoneContextAsPrefix]
Determines whether the received Phone-Context parameter is
added as a prefix to the outgoing ISDN Setup message with (for
digital interfaces) Called and Calling numbers.
[0] Disable (default)
[1] Enable
62.11 SBC Parameters
The SBC and CRP parameters are described in the table below.
Table 62-71: SBC and CRP Parameters
Parameter Description
CRP-specific Parameters
CRP Application
configure voip > application >
enable-crp
[EnableCRPApplication]
Enables the CRP application.
[0] Disable (default)
[1] Enable
Note: For the parameter to take effect, a device reset is
required.
CRP Survivability Mode
configure voip > sbc settings > crp-
survivability-mode
[CRPSurvivabilityMode]
Defines the CRP mode.
[0] Standard Mode (default)
[1] Always Emergency Mode
[2] Auto-answer REGISTER
configure voip > sbc settings > crp-
gw-fallback
[CRPGatewayFallback]
Enables fallback routing from the proxy server to the Gateway
(PSTN).
[0] = Disable (default)
[1] = Enable
To Next Page
Loading...
