Installation & Maintenance Manual 176 Document #: LTRT-40111
Mediant 1000B SBA
20.3 Configuring the Trunk
The procedure below describes basic configuration of the physical trunk.
To configure the physical trunk:
1. Open the Trunk Settings page (Configuration tab > VoIP menu > PSTN > Trunk
Settings).
Figure 20-4: Trunk Settings Page
2. On the top of the page, a bar with trunk number icons displays the status of each
trunk:
• Grey - disabled
• Green - active
• Yellow - RAI alarm
• Red - LOS / LOF alarm
• Blue - AIS alarm
• Orange - D-channel alarm (ISDN only)
Select the Trunk that you want to configure, by clicking the desired trunk number icon.
3. If the trunk is new, configure the trunk as required. If the trunk was previously
configured, click the Stop Trunk button to de-activate the trunk.
To Next Page
Loading...