AudioCodes Mediant 1000B SBA - Defining Exit Operation Upon Process Completion

Installation & Maintenance Manual 212 Document #: LTRT-40111
Mediant 1000B SBA
29.6 Defining Exit Operation upon Process Completion
You can configure the SBA upgrade and recovery to perform a specific operation upon the
completion of the process, using the OnExit parameter.

Start command prompt: Set the OnExit parameter to 0 to start the command prompt
upon process completion:
[Execution] OnExit = 0

Reboot OSN server: Set the OnExit parameter to 1 to reboot the OSN server upon
process completion:
[Execution] OnExit = 1

Shut down OSN server: Set the OnExit parameter to 2 to shut down the OSN server
upon process completion:
[Execution] OnExit = 2
Notes: The recommendation for this configuration is as follows:
• If you are monitoring the procedure by connecting a monitor or serial console, it’s
recommended to set OnExit to 0. This setting displays log messages on the console,
indicating the progress of the SBA upgrade and recovery process.
• If the process is performing automatically without monitoring via a monitor or serial
console, you must set OnExit to 2. In this case, at the end of the upgrade and
recovery process, the OSN server shuts down.