AudioCodes Mediant 1000B SBA - Defining the Local Network; Defining the Disk on Key; Defining the Recovery Partition

Installation & Maintenance Manual 29. Preparing SBA Upgrade and Recovery
Version 6.8 215 Microsoft Lync Server
29.9.2 Defining the Local Network
If the image file is located on a local network (i.e., [ImageSource] Source = 2, as defined in
Section 29.9 on page 214), then you need to define the network path (URI) to where the
file is located and the access username and password.

[LocalNetworkSettings] Path: Defines the network URI:
[LocalNetworkSettings] Path=\\192.168.1.4\images

[LocalNetworkSettings] User: Defines the login user name:
[LocalNetworkSettings] User=audiocodes\john.smith

[LocalNetworkSettings] Password: Defines the password:
[LocalNetworkSettings] Password=1234
29.9.3 Defining the Disk On Key
If the SBA image file is located on the USB dongle (i.e., [ImageSource] Source = 3, as
defined in Section 29.9 on page 214), then you must define the directory path to where the
image file is located. This is defined using the [DOKsettings] DirectoryPath parameter.
The path must be set without the volume (for example, "\recovery\"). The application
searches for this directory in all drives. For the USB root directory, set this parameter to "\"
(default and recommended), as shown below:
[DOKsettings] DirectoryPath=\
29.9.4 Defining the Recovery Partition
If the SBA image file is located on the recovery partition (i.e., [ImageSource] Source = 4),
then you need to define the directory path to where the file is located. This is defined using
the [RecoveryPartition] DirectoryPath parameter.
The path must be defined without the volume (for example, "\recovery\"). The application
searches all the drives for this directory. For recovery partition root, set this parameter to "\"
(recommended and default):
[RecoveryPartition] DirectoryPath=\