AudioCodes Mediant 1000B SBA - 3 Front Panel; Figure 3-1: Mediant 1000 B SBA Front Panel; Table 3-1: Front-Panel Description

Installation & Maintenance Manual 3. Front Panel
Version 6.8 23 Microsoft Lync Server
3 Front Panel
The Mediant 1000B SBA front panel is shown below and described in the subsequent
table.
Figure 3-1: Mediant 1000B SBA Front Panel
Table 3-1: Front-Panel Description
Item #
Label/
Module
Component Description
1 FXS The FXS module provides the Foreign eXchange Subscriber (FXS)
interfaces
Note: The presence of this module depends on the ordered configuration.
If in the future you need to add such interfaces to your device, you can
order this module separately.
FXO The FXO module provides the Foreign eXchange Office (FXO) interfaces
Note: The presence of this module depends on the ordered configuration.
If in the future you need to add such interfaces to your device, you can
order this module separately.
BRI The BRI module provides the Integrated Services Digital Network (ISDN),
Basic Rate Interface (BRI) interfaces.
Note: The presence of this module depends on the ordered configuration.
If in the future you need to add such interfaces to your device, you can
order this module separately.
TRUNKS TRUNKS (E1/TE/J1) module
Note: The presence of this module depends on the ordered configuration.
If in the future you need to add such interfaces to your device, you can
order this module separately.
2 MPM MPM module for IP media server capabilities (i.e., conferencing, SBC,
and IP-to-IP routing applications). Depending on required configuration,
the MPM module can be housed in chassis slots 3, 4, 5, or 6.
Note: The presence of this module depends on the ordered configuration.
If in the future you need to add such interfaces to your device, you can
order this module separately.
3 CRMX CRMX module - The CRMX module provides LAN interfaces (providing
port-pair redundancy), an RS-232 interface, and a reset pinhole button.
4 SWX LAN Extension (SWX) module – The SWX LAN Expansion module
provides four LAN ports. These ports provide port-pair (group)
redundancy, where one port is active and the other redundant.
Note: The presence of this module depends on the ordered configuration.