Installation & Maintenance Manual C. Upgrading Hardware
Version 6.8 283 Microsoft Lync Server
3. Install the OSN module:
a. Remove the blank-panel slot cover from Slot 2, by gently pulling on the handle of
the module until it slides out of the slot.
b. Hold the OSN module in the correct orientation, as shown in the figure below, and
gently insert the module into the slot, sliding it along the slot's guide rails until it
makes contact with the card-edge connector located on the backplane.
Figure C-2: Installing OSN Module
c. Push the module's handle until it clicks firmly into the slot.
4. Install the SBA application on the OSN platform using the supplied USB Upgrade and
Recovery dongle (see Chapter 30 on page 217).
5. Prepare the SBA at the Data Center (see Chapter 8 on page 55 and Chapter 9 on
page 57).
6. Connect to the SBA Management Interface (see Chapter 10 on page 71).
7. Complete the SBA installation and configuration (see Chapter 11 on page 79).
To Next Page
Loading...