Installation & Maintenance Manual C. Upgrading Hardware
Version 6.8 287 Microsoft Lync Server
4. Insert the new HDMX module into Slot #1:
a. Hold the new HDMX module in the correct orientation, as shown in the figure
below, and gently insert the module into the slot, sliding it along the slot's guide
rails until it makes contact with the card-edge connector located on the
backplane.
Figure C-6: Replacing HDMX Module
b. Push the module's handle until it clicks firmly into the slot.
5. Insert the new OSN3B or OSN4 module into Slot #2:
a. Hold the new OSN module in the correct orientation, as shown in the figure
below, and gently insert the module into the slot, sliding it along the slot's guide
rails until it makes contact with the card-edge connector located on the
backplane.
Figure C-7: Replacing OSN Module
b. Push the module's handle until it clicks firmly into the slot; the operating system
on the OSN server starts up.
To Next Page
Loading...