Installation & Maintenance Manual 10. Initially Connecting to the SBA Management Interface
Version 6.8 71 Microsoft Lync Server
10 Initially Connecting to the SBA
Management Interface
The SBA Web-based, graphical user interface (GUI) tool is used for installing and
configuring the SBA application running on the Mediant 1000B SBA OSN server.
Note: The SBA Management Interface is supported from Internet Explorer 9 and later
(Compatibility disabled), Firefox, and Google Chrome.
You can initially connect and log in to the SBA Management Interface using one of the
following methods:
Using the internal NIC: the SBA is connected to the network via the gateway/SBC
Ethernet port and the device's internal switch. See below.
If this option is used, only a single network cable is required (for connecting to the
gateway/SBC Ethernet port).
Using the external NIC: the SBA is connected to the network via the Ethernet port on
the OSN server. See Section
10.1.2 on page 76.
If this option is used, two network cables are required; one for connecting to the OSN
server Ethernet port and the other for connecting to the gateway/SBC application
Ethernet port.
Note: It is highly recommended to use the external NIC option because when the internal
NIC option is used and the gateway/SBC is reset via the device's Web server, then the
SBA network connection is lost.
To Next Page
Loading...