Installation & Maintenance Manual 72 Document #: LTRT-40111
Mediant 1000B SBA
10.1.1 Initially Connecting to the SBA Using the Internal NIC
When you initially connect to the SBA using the internal NIC, the network cable should be
connected to one of the gateway/SBC Ethernet ports on the device's front panel; this port
connects to the device's internal switch, which then connects to the OSN module. When
this option is used, there is no pre-configured factory default IP address, and therefore the
network address must be acquired using DHCP or assigned with a static IP address.
To initially connect to the SBA using the internal NIC:
1. Connect the first Ethernet port on the CRMX module on the front panel of the device
directly to the network using a straight-through Ethernet cable.
Figure 10-1: Connecting Mediant 1000B SBA LAN Port on CRMX Module (Front Panel)
2. If you wish to monitor the connection process via an HDMI monitor, do the following
(otherwise, skip to Step 3):
a. Connect the USB hub into the USB hub port on the OSN3B and OSN4 server.
b. Plug the mouse and keyboard into respective connectors on the USB hub.
c. Using the supplied MINI HDMI TO HDMI 1.5m cable, connect the Micro HDMI
port on the OSN3B or OSN4 module using a Mini HDMI connector and connect
the other end to the HDMI port on the monitor using a Type-D male connector.
For HDMI connector cable pinouts, see Section 5.1.4.
To Next Page
Loading...