Installation & Maintenance Manual 10. Initially Connecting to the SBA Management Interface
Version 6.8 73 Microsoft Lync Server
Figure 10-2: HDMI Connection
d. Determine the NIC used for the Ethernet port, by removing the network cable
from the Ethernet port and viewing on the monitor that the NIC (ID) has changed
to "Disconnected". This is the NIC corresponding to the LAN port.
e. Reconnect the network cable and then do one of the following:
♦ If you have a DHCP server in your network, note the IP address assigned to
the Ethernet port.
♦ If you are not using a DHCP server, then assign a static IP address to the
NIC of the Ethernet port.
f. Open a standard Web browser (see Step 9).
3. Connect your PC to the OSN server's serial port:
• OSN3B/OSN4: Using the supplied micro USB to USB cable adapter, connect the
micro USB connector end to the OSN3B/OSN4 serial port ( ), and then
connect the other end of the cable (USB) to the serial interface port on your PC.
Figure 10-3: Cabling OSN3B and OSN4 to PC for Serial Communication
To Next Page
Loading...