Installation & Maintenance Manual 11. Installing and Configuring the SBA
Version 6.8 81 Microsoft Lync Server
11.1 Step 1: Define IP Settings
The IP Settings option defines the IP address and domain name server (DNS).
To set the IP address and DNS:
1. Select the Setup tab, and then select the 'IP Settings' check box; the following screen
is displayed:
Figure 11-2: Set IP Configuration Page
1. Clear the 'Enable / Disable NIC' check box for those interfaces that you are not using.
2. From the drop-down list, select one of the following NIC interface options:
• External1 – Corresponds to one of the physical Ethernet ports on the Mediant
1000B rear panel.
• External2 – Corresponds to one of the physical Ethernet ports on the Mediant
1000B rear panel.
• Internal1 – Internal port that connects the OSN server to the gateway's CRMX
module.
• Internal2 – Internal port that is not in use.
Note:
• The assignment of the physical ports (Port 1 and Port 2) to the External1 and
External2 NICs is random.
• For the OSN3 module, only a single External port is available (labeled "External").
To Next Page
Loading...