Configuration Note 5. Gateway Configuration
Version 6.8 23 Mediant 1000B
5.9 Step 7: Configure SIP Environment and Gateway
Name
This step describes how to configure the SIP Environment and Gateway Name.
To configure the SIP Environment and Gateway Name:
Open the 'Proxy & Registration' page (Configuration tab > VoIP > SIP Definitions >
Proxy & Registration).
1. In the 'Gateway Name' field, enter an FQDN name to the gateway (for example, SIP-
GW.com). Any gateway name that corresponds to your network environment is
applicable, but it must meet requirements for FQDNs.
Figure 5-8: Proxy & Registration
2. Open the 'Proxy & Registration' page (Configuration tab > VoIP > VoIP Network >
Proxy Sets Table).
3. From the 'Proxy Set ID' drop-down list, select 1.
Figure 5-9: Proxy Set ID
4. In the ‘Proxy Address’ field, enter either the IP address or FQDN of the Avaya Aura
Messaging (AAM). If your Avaya Aura Messaging system includes multiple AAM’s,
then enter multiple IP addresses or FQDNs for the MAS’s - one AAM per table row. It
is recommended that you use FQDNs.
To Next Page
Loading...
