Version 7.2 1081 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
Note: The parameter is applicable only if the G.711 coder is used.
configure voip > sip-
d
rport-support
[EnableRport]
Enables the usage of the 'rport' parameter in the Via header.
[0] = Disabled (default)
[1] = Enabled
The device adds an 'rport' parameter to the Via header of each
outgoing SIP message. The first Proxy that receives this message
sets the 'rport' value of the response to the actual port from where the
request was received. This method is used, for example, to enable the
device to identify its port mapping outside a NAT.
If the Via header doesn't include the 'rport' parameter, the destination
port of the response is obtained from the host part of the Via header.
If the Via header includes the 'rport' parameter without a port value,
the destination port of the response is the source port of the incoming
request.
If the Via header includes 'rport' with a port value (e.g., rport=1001),
the destination port of the response is the port indicated in the 'rport'
parmeter.
Enable X-Channel Header
configure voip > sip-
definition settings > x-
channel-header
[XChannelHeader]
Enables the device to add the SIP X-Channel header to outgoing SIP
messages. The header provides information on the physical Trunk/B-
channel on which the call is received or sent.
[0] Disable = (Default) X-Channel header is not used.
[1] Enable = X-Channel header is generated by the device and
sent in SIP INVITE requests and 180, 183, and 200 OK responses.
The header includes the Trunk number, B-channel and the
device's IP address, using the following syntax:
x-channel: ds/ds1-<Trunk number>/<B-
channel>;IP=<device's IP address>
For example, the below shows a call on Trunk 1, channel 4 of the
device with IP address 192.168.13.1:
x-channel: ds/ds1-1/4;IP=192.168.13.1
Progress Indicator to IP
configure voip > sip-
definition settings > prog-
ind-2ip
[ProgressIndicator2IP]
Global parameter defining the progress indicator (PI) sent to the IP.
You can also configure the functionality per specific calls, using IP
Profiles (IpProfile_ProgressIndicator2IP) or Tel Profiles
(TelProfile_ProgressIndicator2IP). For a detailed description of the
parameter and for configuring the functionality, see Configuring IP
Profiles on page 423 or Configuring Tel Profiles on page 459.
Note: If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls associated with
the profile.
[EnableRekeyAfter181] Enables the device to send a re-INVITE with a new (different) SRTP
key (in the SDP) if a SIP 181 response is received ("call is being
forwarded"). The re-INVITE is sent immediately upon receipt of the
200 OK (when the call is answered).
[0] = Disable (default)
[1] = Enable
Note: The parameter is applicable only if SRTP is used.
configure voip > sip-
definition settings >
number-of-active-
Defines the maximum number of concurrent, outgoing SIP REGISTER
dialogs. The parameter is used to control the registration rate.
To Next Page
Loading...
