User's Manual 1150 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
Note: The parameter is applicable only to FXS interfaces.
configure voip > sip-
definition settings >
enable-did
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX. The
DID signal can be sent alone or combined with an NTT Caller ID signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable; EnableDID_Port,
EnableDID_Module;
[\EnableDID]
Where,
IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem DID
support.
Port = Port number.
Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: The parameter is applicable only to FXS interfaces.
configure voip >
interface fxs-fxo > wink-
time
[WinkTime]
Defines the time (in msec) elapsed between two consecutive polarity
reversals. The parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Note: For the parameter to take effect, a device reset is required.
65.10.5.13 ISDN BRI Parameters
The ISDN BRI call forwarding service parameters are described in the table below.
Table 65-54: BRI Call Forwarding Services Parameters
Parameter Description
BRI-to-SIP Supplementary Services Codes for Call Forward
For more information, see ''BRI Call Forwarding'' on page 582.
Call Forward Unconditional
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-code
[SuppServCodeCFU]
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward Unconditional
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
To Next Page
Loading...
