AudioCodes Mediant 1000B - Page 1153

Version 7.2 1153 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description

[6] E1 TRANSPARENT 30 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31,
excluding time slot 16 of all trunks are mapped to DSP
channels.
 [7] E1 MFCR2 = Common E1 MFC/R2 CAS protocols
(including line signaling and compelled register signaling).
 [8] E1 CAS = Common E1 CAS protocols (including line
signaling and MF/DTMF address transfer).
 [9] E1 RAW CAS
 [10] T1 NI2 ISDN = National ISDN 2 PRI protocol
 [11] T1 4ESS ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 4ESS switch.
 [12] T1 5ESS 9 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-9 switch.
 [13] T1 5ESS 10 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-10 switch.
 [14] T1 DMS100 ISDN = ISDN PRI protocol for the Nortel™
DMS switch.
 [15] J1 TRANSPARENT
 [16] T1 NTT ISDN = ISDN PRI protocol for the Japan - Nippon
Telegraph Telephone (known also as INS 1500).
 [17] E1 AUSTEL ISDN = ISDN PRI protocol for the Australian
Telecom.
 [18] E1 HKT ISDN = ISDN PRI (E1) protocol for the Hong
Kong - HKT.
 [19] E1 KOR ISDN = ISDN PRI protocol for Korean Operator
(similar to ETSI).

[20] T1 HKT ISDN = ISDN PRI (T1) protocol for the Hong Kong
- HKT.
 [21] E1 QSIG = ECMA 143 QSIG over E1
 [22] E1 TNZ = ISDN PRI protocol for Telecom New Zealand
(similar to ETSI)
 [23] T1 QSIG = ECMA 143 QSIG over T1
 [30] E1 FRENCH VN6 ISDN = France Telecom VN6
 [31] E1 FRENCH VN3 ISDN = France Telecom VN3
 [34] T1 EURO ISDN =ISDN PRI protocol for Euro over T1
 [35] T1 DMS100 Meridian ISDN = ISDN PRI protocol for the
Nortel™ DMS Meridian switch
 [36] T1 NI1 ISDN = National ISDN 1 PRI protocol
 [40] E1 NI2 ISDN = National ISDN 2 PRI protocol over E1
 [50] BRI EURO ISDN = Euro ISDN over BRI
 [51] BRI NI2 ISDN
 [52] BRI DMS 100 ISDN
 [53] BRI 5ESS 10 ISDN
 [54] BRI QSIG = QSIG over BRI
 [55] BRI VN6 = VN6 over BRI
 [56] BRI NTT = BRI ISDN Japan (Nippon Telegraph)
Note:
 All PRI trunks must be configured as the same line type (either
E1 or T1). The device can support different variants of CAS