Version 7.2 1195 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
Note: If the functionality is configured for a specific Tel Profile,
the settings of the global parameter is ignored for calls
associated with the Tel Profile.
Time Before Reorder Tone
time-b4-reordr-tn
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates call)
until the device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
Cut Through Reorder Tone
Duration
cut-thru-reord-dur
[CutThroughTimeForReOrderTone]
Defines the duration (in seconds) of the reorder tone played to
the Tel side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call
is immediately answered if the FXS is off-hooked (for analog
interfaces) or the PSTN is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no reorder
tone is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) or CutThrough (for FXS
channels) parameter.
Enable Comfort Tone
comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone
Type #18) to the FXS/FXO endpoint after a SIP INVITE is sent
and before a SIP 18x response is received.
[0] Disable (default)
[1] Enable
Note: The parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration] Defines the duration (in seconds) for which the offhook warning
tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Note:
A negative value indicates that the tone is played infinitely.
The parameter is applicable only to analog interfaces.
Play Busy Tone to Tel
configure voip > sip-definition
settings > play-bsy-tone-2tel
[PlayBusyTone2ISDN]
Enables the device to play a busy or reorder tone to the PSTN
after a Tel-to-IP call is released.
[0] Don't Play = (Default) Immediately sends an ISDN
Disconnect message.
[1] Play when Disconnecting = Sends an ISDN Disconnect
message with PI = 8 and plays a busy or reorder tone to the
PSTN (depending on the release cause).
[2] Play before Disconnect = Delays the sending of an ISDN
Disconnect message for a user-defined time (configured by
the TimeForReorderTone parameter) and plays a busy or
reorder tone to the PSTN. This is applicable only if the call is
released from the IP [Busy Here (486) or Not Found (404)]
before it reaches the Connect state; otherwise, the
Disconnect message is sent immediately and no tones are
played.
Note: The parameter is applicable only to digital interfaces.
q850-reason-code-2play-user-tone
[Q850ReasonCode2PlayUserTone]
Defines an ISDN Q.8931 release cause code(s), which if
mapped to the SIP release reason received from the IP side,
To Next Page
Loading...
