AudioCodes Mediant 1000B - Page 1266

User's Manual 1266 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Table 65-80: HTTP Proxy Service Parameters
Parameter Description
HTTP Proxy Application
configure network >
http-proxy settings >
http-proxy-app
[HTTPProxyApplication]
Enables the HTTP Proxy application.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
HTTP Proxy Debug Level
configure network >
http-proxy settings >
http-proxy-debug-level
[HTTPProxySyslogDebugLevel]
Enables debugging of HTTP services.
 [0] No Debug = (Default) Disable.
 [1] Basic = Enables debug and sends basic information in
Syslog.
 [2] Detailed = Enables debug and sends basic information in
Syslog.
HTTP Interfaces Table
HTTP Interfaces
configure network >
http-proxy > http-
interface
[HTTPInterface]
Defines local listening interfaces for receiving HTTP/S requests
from Web clients for HTTP/S-based services.
The format of the ini file table parameter is as follows:
[ HTTPInterface ]
FORMAT HTTPInterface_Index = HTTPInterface_InterfaceName,
HTTPInterface_NetworkInterface, HTTPInterface_Protocol,
HTTPInterface_Port, HTTPInterface_TLSContext,
HTTPInterface_VerifyCert;
[ \HTTPInterface ]
For more information, see ''Configuring HTTP Interfaces'' on page
285.
HTTP Proxy Services Table
HTTP Proxy Services
configure network >
http-proxy http-proxy-
serv
[HTTPProxyService]
Defines HTTP Proxy based services.
The format of the ini file table parameter is as follows:
[ HTTPProxyService ]
FORMAT HTTPProxyService_Index =
HTTPProxyService_ServiceName,
HTTPProxyService_ListeningInterface,
HTTPProxyService_URLPrefix,
HTTPProxyService_KeepAliveMode;
[ \HTTPProxyService ]
For more information, see ''Configuring HTTP Proxy Services'' on
page 287.
HTTP Proxy Hosts Table
HTTP Proxy Hosts
configure network >
http-proxy http-proxy-
host
[HTTPProxyHost]
Defines HTTP Proxy hosts. The table is a "child" of the HTTP Proxy
Services table (HTTPProxyService). An HTTP Proxy Host
represents the HTTP-based managed equipment (e.g., IP Phone).
The format of the ini file table parameter is as follows:
[ HTTPProxyHost ]
FORMAT HTTPProxyHost_Index =
HTTPProxyHost_HTTPProxyServiceId,
HTTPProxyHost_HTTPProxyHostId,
HTTPProxyHost_NetworkInterface, HTTPProxyHost_IpAddress,
HTTPProxyHost_Protocol, HTTPProxyHost_Port,
HTTPProxyHost_TLSContext, HTTPProxyHost_VerifyCert;