Version 7.2 311 Mediant 1000B Gateway & E-SBC
User's Manual 15. Services
8. Configure routing rules to route the calls in the network.
9. For SBC calls: Configure IP Groups to represent your call party entities, and assign
them the group of Call Setup Rules (Set ID) that you configured in Step 7 (above). For
Gateway calls: Assign the group of Call Setup Rules (Set ID) that you configured in
Step 7 (above) to your Tel-to-IP Routing rules (see Configuring Tel-to-IP Routing
Rules on page 511).
To Next Page
Loading...
