AudioCodes Mediant 1000B - Page 441

Version 7.2 441 Mediant 1000B Gateway & E-SBC
User's Manual 20. Coders and Profiles
Parameter Description
SIP entity in dialog-setup transactions. The Contact header
remains unchanged.
 [2] Transparent = Device doesn't change the Contact header and
doesn't add a Record-Route header for itself. Instead, it relies on
its' own inherent mechanism to remain in the route of future
requests in the dialog (for example, relying on the way the
endpoints are set up or on TLS as the transport type).
Keep Incoming Via Headers
sbc-keep-via-headers
[IpProfile_SBCKeepVIAHeade
rs]
Enables interworking SIP Via headers between SIP entities. The
parameter defines the device's handling of Via headers for
messages sent to the SIP entity associated with the IP Profile.
 [-1] According to Operation Mode = Depends on the setting of the
'Operation Mode' parameter in the IP Groups table or SRDs table:

B2BUA: Device operates as if the parameter is set to Disable
[0].

Call State-full Proxy: Device operates as if the parameter is
set to Enable [1].
 [0] Disable = Device removes all Via headers received in the
incoming SIP request from the other leg and adds a Via header
identifying only itself, in the outgoing message sent to the SIP
entity.
 [1] Enable = Device retains the Via headers received in the
incoming SIP request and adds itself as the top-most listed Via
header in the outgoing message sent to the SIP entity.
Keep Incoming Routing
Headers
sbc-keep-routing-headers
[IpProfile_SBCKeepRoutingH
eaders]
Enables interworking SIP Record-Route headers between SIP
entities. The parameter defines the device's handling of Record-
Route headers for request/response messages sent to the the SIP
entity associated with the IP Profile.
 [-1] According to Operation Mode = (Default) Depends on the
setting of the 'Operation Mode' in the IP Group or SRDs table:

B2BUA: Device operates as if the parameter is set to Disable
[0].

Call State-full Proxy: Device operates as if the parameter is
set to Enable [1].
 [0] Disable = Device removes the Record-
Route headers received
in requests and responses from the other side, in the outgoing
SIP message sent to the SIP entity. The device creates a route
set for that side of the dialog based on these headers, but doesn't
send them to the SIP entity.
 [1] Enable = Device retains the incoming Record-Route headers
received in requests and non-failure responses from the other
side, in the following scenarios:

The message is part of a SIP dialog-setup transaction.

The messages in the setup and previous transaction didn't
include the Record-Route header, and therefore hadn't set
the route set.
Note: Record-Routes are kept only for SIP INVITE, UPDATE,
SUBSCRIBE and REFER messages.
Keep User-Agent Header
sbc-keep-user-agent
[IpProfile_SBCKeepUserAgen
tHeader]
Enables interworking SIP User-Agent headers between SIP entities.
The parameter defines the device's handling of User-Agent headers
for response/request messages sent to the SIP entity associated
with the IP Profile.