AudioCodes Mediant 1000B - Page 739

Version 7.2 739 Mediant 1000B Gateway & E-SBC
User's Manual 36. Configuring Dial Plans
and then click the Dial Plan Rule link located below the table; the Dial Plan Rule table
appears.
6. Click New; the following dialog box appears:
Figure 36-3: Dial Plan Rule Table - Add Dialog Box
7. Configure a dial plan rule according to the parameters described in the table below.
8. Click New, and then save your settings to flash memory.
Table 36-3: Dial Plan Rule Table Parameter Descriptions
Parameter Description
Index
index
[DialPlanRule_RuleIndex]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
name
[DialPlanRule_Name]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 15 characters.
Prefix
prefix
[DialPlanRule_Prefix]
Defines the prefix number of the source or destination number.
The valid value is up to 50 characters. The following syntax can
be used:
 0-9: Specific digit.
 x: Wildcard denoting any digit from 0 through 9.
 z: Denotes a number from 1 through 9.
 n: Denotes a number from 2 through 9.
 a-z: Lower-case letter.
 A-Z: Upper-case letter.
 *: (Asterisk symbol) If it is the only character in the rule, it
denotes any number. To denote the asterisk "*" symbol itself,
precede it with the escape "\\" character (see below).
 \\: (Backslash escape character) When it prefixes a wildcard
character (*, z, n, and x), the character itself is used and not
the meta-meaning. For example, "\\x" denotes the character
"x", while "x" is the wildcard denoting any digits from 0-9.
 #: (Pound or hash symbol) When used at the end of the prefix
it denotes the end of the number. For example, "54324#"
represents a 5-digit number that starts with the digits 54324.